Keywords：
channel forming machine
canal lining machine
canal concrete forming machine
canal lining equipment
cast-in-place canal lining
A channel forming machine travels along the prepared channel bed and uses a mould to form concrete lining to the exact canal profile. Because the profile is set by the mould rather than by manual screeding, lining thickness stays uniform over long runs.
Anyang Yuhua builds channel forming machines for working widths of 0.5–8 m and lining thickness of 60–200 mm. The machine is also called a canal lining machine or canal concrete forming machine.
Configuration depends on the canal cross-section (bottom width, slope ratio), required output and the level of automation — which is why quotations are configured rather than quoted from a flat list price.
Frequently Asked Questions
What is a channel forming machine?
A self-propelled machine that places, vibrates and levels concrete in one continuous pass along the canal axis. Because the profile is set by the mould rather than by manual screeding, lining thickness stays uniform over long runs.
What lining thickness can Yuhua machines produce?
The typical range is 60-200 mm. The actual thickness is set by the project and configured on the machine.
What working width is available?
Working width is 0.5-8 m. For full cross-sections, Yuhua also builds machines that form the bed and both slopes in a single pass.
How is canal lining different from slipform forming?
Lining places concrete onto a prepared canal bed, while slipform forming extrudes concrete through a moving mould to produce a monolithic section without conventional formwork. The choice depends on the canal section and the required output.
Questions about this topic?
Contact Us